Technoton GNOM DDE Axle Load Sensor

Pressure sensor GNOM DDE is used to determine the axle load in vehicles equipped with air suspension in transport telematics systems.


Pressure sensor GNOM DDE is used to determine the axle load in vehicles equipped with air suspension in transport telematics systems.
Pressure sensor measures the pressure in the vehicle pneumatic system and transmits data as an analog signal to telematics terminal. It is recommended to use online terminals gateway CANUp  to organize transport tracking with axle load and weight monitoring or use MasterCAN Display 35




Technoton was established in April 2000, at the early stage of emerging market of automotive telematics and GPS tracking systems. We started with development and manufacture of GPS tracking devices, fuel level sensors and fuel flow meters. Soon we focused on solving tasks of fuel consumption measurement and fuel usage monitoring, safe CANbus data reading and analysis.

Technoton’s technical team includes highly-qualified engineers and developers, who have wide expertise in micro controller units, mechanical engineering, computer science, programming and diagnosis.


  • compliance with European and Russian automobile standards;
  • the linear characteristic of the output signal simplifies data processing by a fleet monitoring system;
  • the output signal is stabilized and doesn’t depend on onboard voltage;
  • short circuit and cords confusion protection;
  • mounting elements included.


• Axle load
• In-motion cargo weight measurement
• Heavy and Lightweight trucks with or without trailer
• Road assistance trucks
• Garbage trucks
• Concrete mixers and etc.


Inlet pressure, MPa 0…0.8
Supply voltage, V 8…32
Ingress Protection Rating IP55
Thread М16х1,5
Operating temperature, °С -40…+80
Weight, g, not more than 150

Additional Informations

Mounting kit GNOM MK DDE




Mounting kit GNOM MK DDE2  is used for GNOM DDE sensor mounting into air suspension in following cases:

  • mounting of GNOM DDE into M22x1.5 thread hole with the resumption of compressed air supply pipeline; GNOM DDE mounting into gap of Ø=8 mm pipeline (compressed air supply pipe);
  • GNOM DDE mounting into Ø=8 mm supply pipeline fitting.

GNOM MK DDE2 contains only high-quality components specially designed for use in vehicle air suspension system.

Mounting kit set :

1. Conical sleeve – 2 pcs.;
2. Fitting adapter (T splitter) – 1 pc.;
3. Nipple – 2 pcs.;
4. Pipeline Ø=8 mm – 1 pc.;
5. O-ring – 2 pcs.;
6. O-ring – 1 pc.;
7. Swivel nut – 2 pcs.;

8. Washer 16 – 1 pc.;
9. Mounting bracket – 1 pcs.;
10. Screw M6x8 – 2 pcs.;
11. Self-tapping screw 6.3×13 – 2 pcs.;
12. Bolt M6x20 – 2 pcs.;
13. Nut M6 – 2 pcs.;
14. Washer M6 – 2 pcs.;